Iphone/ Ipod Touch 2G

HOW TO JAIL BREAK THE IPOD TOUCH 2G  (sources below) (Iphone jailbreak below this)

Here is the Jailbreak for the Second Generation iPod Touch: Untethered! (For XP + Vista)
It is  simple to Jailbreak you iPod with QuickFreedom. This tutorial is very detailed and not for everyone. If you are even remotely computer savvy then it will be a breeze. QuickFreedom does a good job of explaining everything. If you still don’t know how to, here you go:

1. Click Here to download the installer.

2. Double click the installer now located in your download folder

3. Install QuickFreedom by clicking next through the installer.

4. Open QuickFreedom (looks like the image above).

5. Click Jailbreak.

  • The next page will check to see if LIBUSB has been installed. If it has then you should see a green check, if it has not then click the install button to the right.
  • The Same applies for the the Original Firmware 2.2.1. If you don’t have the firmware already installed click Download. Then Browse to find it in your download folder.

8. Once both have been installed click Next.

9. Check Install Installer (recommended). Check Use Custom Boot Logo (if you want a custom boot logo).

  • Once Checked, a window should open asking you what type of boot logo you want. You can also use your own custom boot logo here as well.

10. Click Create Firmware.

  • Takes about 5 minutes depending on your specs.
  • A window should pop up saying, “Your ipsw has been completed and patched successfuly”.
  • Click OK
  • You should also see that you now have a new Custom Firmware.ipsw on your desktop.

11. Click Next.

12. Connect your iPod to the computer and put your iPod into DFU mode.

  • If you don’t know how, follow the instructions by clicking DFU Instructions.
  • After doing so the log should state, ” iPod Connected in DFU Mode, Press Start-Prejailbreak“.
  • If for any reason it says, “iPod not found” just unplug your iPod and plug it back in.

13. Press Start Pre-Jailbreak.

  • Your iPod should Turn White.
  • A window should pop up saying, ” iPod successfully put into Pre-Jailbreak Mode. Now restore your custom firmware in iTunes. This file is located on your desktop“.
  • Click OK.

14. Click Next.

15. It will tell you how to restore you custom firmware. Do this by:

  • Opening iTunes.
  • Hold Shift & click Restore.
  • A browse window will open.
  • In the browse window, find the Custom Firmware.ipsw located on your desktop.  Click it.
  • Click Open.

16. Your iPod will now restore.

17. After this a iTunes window will open telling you it has been restored and that it is now restarting.

18. iTunes will now ask you to setup the iPod.

19. You have now Jailbroken your iPod Touch Second Generation!

20. Congrats!!!

IPHONE JAILBREAK

The iPhone Dev team released their much awaited software solution to unlock iPhone 3G OS 3.0 with UltraSn0w a replacement of YellowSn0w. However to install their UltraSn0w application to unlock iPhone 3G, you need to first jailbreak iPhone 3G. So here is a step-by-step guide to jailbreak iPhone 3G using QuickPwn for Windows and Mac users. For unlocking your iPhone 3G first jailbreak with following guide after a successful jailbreak follow our guide on Unlocking iPhone 3G with UltraSn0w. For more information on UltraSn0w check here. Before getting started please ensure that you have upgraded iTunes to iTunes 8.2 Final version.


Step One : Create a folder on desktop and name it whatever you wants in the following article we named it iHackintosh. Now put all your downloaded files in the iHackintosh folder. Now connect your iPhone to the computer and launch iTunes.

Step Two : Select your iPhone from the list of devices on the left. Now hold down shift and click the Restore button. Restore is preferred as it won’t create any wasted space on your iPhone.

Step Three : Navigate to the iHackintosh folder on your desktop and select the 3.0 firmware ipsw. Click the Open button to continue.

Step Four : Once iTunes has finished updating your iPhone to the 3.0 firmware you may launch QuickPwn from the iHackintosh folder on your desktop.

Step Five : Make sure you iPhone is connected to the computer and click the blue arrow to continue.

Step Six : Click the Browse button to locate your iPhone firmware.

Step Seven : Select the 3.0 firmware ipsw from the Pwnage folder on your desktop then click the Open button.

Step Eight : QuickPwn will check to make sure the ipsw is valid. Click the blue arrow button to continue.

Step Nine : You can now select whether to Add Cydia, Add Installer, or Replace Boot Logos. Select the ones you would like to perform then click the clue arrow button. Installing Cydia and Installer is highly recommended to enjoy the full jailbreak experience.

Step Ten :QuickPwn will now ask you to confirm your iPhone 3G is still connected via USB cable before it continues. Click the blue arrow button to proceed.

Step Eleven : QuickPwn will now automatically put your iPhone into recovery mode. Once its in recovery mode you will be prompted to: Hold the Home button for 5 seconds, Hold the Home and Power buttons for 10 seconds, then release the Power button and continuing holding the Home button until your iPhone is in DFU mode.

Step Twelve : Once QuickPwn detects your iPhone 3G in DFU mode it will begin the jailbreaking process.

Step Thirteen : Once jailbreaking is complete QuickPwn will inform you that it was successful. If everything goes fine you’ll see your iPhone with Cydia available on the main screen. If you are looking a step towards and wants to unlock your iPhone from carrier restrictions then follow our upcoming guide on Unlock the iPhone 3G OS 3.0 with UltraSn0w.

SOURCES

So of course after the jailbreak, two of the most important applications are Cydia and Installer 4. Cydia has emerged as the source for apps and themes to customize your iPhone. Installer 4 is still in its beta stage so expect a bit more from it coming soon.

One of the most helpful Cydia apps is MobileSubstrate, which will enable you to make Skype calls over 3G. By using this app with Skype’s $2.95US/month unlimited calling to Canada/USA, you can bypass your carrier’s expensive long distance charges! For example, long distance within Canada costs $0.35/min on Rogers, but Skype will cost you $0.02/min!

Click here on how to download Skype in Canada by creating a free US iTunes account without credit card.

Here are a list of my sources for Cydia (some are by default):
– BigBoss & Planet-iPhone: http://apt.bigboss.us.com/repofiles/cydia/
– ModMyiFone: http://modmyifone.com/repo/
– Ste Packaging: http://repo.smxy.org/cydia/apt/
– iSpazio: http://ispaziorepo.com/cydia/apt
– Telesphoreo Tangelo: http://apt.saurik.com/
– ZodTTD: http://www.zodttd.com/repo/cydia/

Other notables:
– intelliborn: http://intelliborn.com/cydia
– FreeCoder: http://iphone.freecoder.org/apt/
– Hack&Dev.org: http://iphone.hackndev.org/apt/
– SaladSoft: http://nickplee.com/cydiasource/
– Urbanfanatics.com: http://urbanfanatics.com/cydia/
– iPhoneCake: http://cake.mapleidea.com/cydia/
– WeiPhone: http://app.weiphone.com/cydia/
– iFoneTec: http://app.ifonetec.com/cydia/
– iSpazio: http://ispaziorepo.com/cydia/apt
– Andy Dam: http://repo.gafoogle.com/
– Steffwiz: http://steffwiz.webs.com/iPhone/Repo

To add sources: Launch Cydia—>Manage—>Sources—>Edit—>Add—>enter the URL—>click Add Source

Here are the sources for Installer 4 so far:
– RiP Dev – http://i.ripdev.com/
– BigBoss’s Apps and Things. – http://apptapp.thebigboss.org/repofiles/installer4/
– iSpazio Official – http://repo.neolinus.org/ispazio/
– Ste Packaging – http://repo.smxy.org/installer4/
– ClubiFone – http://www.clubifone.com/repo/
– iPhone-notes.de – http://sendowski.de/iphone/
– a27 Dev Team: http://a27dev.com/installer/repo/
– Hackmyiphone: http://hackmyiphone.net/installer/
– Wildcat: http://iphone.handheld.com.vn/installer
– iClarified: http://installer.iClarified.com
– Modmyifone: http://i.modmyifone.com/

To add sources: Launch Installer 4—>Sources—>Edit—>click the “+”—>type in source URL—>click Done

Big thanks to the MacRumors forums and iPodTouchFans forums for helping with compiling this! I haven’t tested all of these sources so be wise about it! :) If you have some sources that I did not list, feel free to add them in the comments. All credit goes to ihackintosh.com and ipodtouchhacks.com

Post a Comment

Required fields are marked *

*
*